The style of the grease gun hose is more and more diversified, but the basic principle of the grease gun is similar. The nozzle is divided into two types: the tip and the mouth. The accessories are also hose and tube. . The usual construction of a grease gun consists of a handle, a gun head, a barrel, and a handle.

    The interior is made up of a leather bowl and a spring. Steel ball, exhaust screw and other components. Nowadays, the butter guns on the market are all simple to present oil spills, sand, and oil, which are the most troublesome things for the operators. Usually, the grease gun simply leaks into the sand. One is the problem of the grease gun itself, and the other is a newcomer.

    It is not very clear about how to use the grease gun. The fault of the operation leads to the poor use of the grease gun.

    Needle about some problems in the application. We are able to think of ways to prevent, for example, sand.

    Once you have mixed a few grains of sand in the butter, and you are using a pointed nozzle at the moment, then you are too angry to throw the oil gun to hate it. And there is definitely no advantage in terms of equipment, but in fact, most of this is formed by myself. Therefore, we must insist on the cleanliness of the butter used. Do not use unclean things to refuel, and drain the oil container in time. In addition, a 40-mesh to 60-intentioned metal filter is placed in the nozzle. This method is very useful. Another problem in use is that it can't be oiled.

    The grease gun hose forms a reduced pressure in the incinerator, a lack of engine power, and a water spray from the radiator. The initiator cylinder head is warped and deformed due to long-term operation under high temperature, high pressure, heat load and alternating load, and the cylinder head gasket is damaged from the waterway mouth. The correction method selected by us is that after the disassembly, the cylinder block is found. The cylinder head is deformed. After changing the cylinder heads twice, each one was washed out after one month. The flatness of the cylinder block is 50μm, which is also suitable for the skill needs. Because there is no incineration chamber concave on the cover, but the flatness of the cylinder head is wrong, it reaches 0.20mm, which is the main reason for the cylinder gasket being damaged. Do not think about the change of the incineration volume, and use the method of first tightening and then tightening the cylinder head bolts. The butter machine initiates the repair of the cylinder head deformation.

    lianghang Specializing in the production of electric pump, foot oiler, boutique grease gun, hand pump, Yangliu heavy grease gun and other products, welcome to inquire. Phone 0579-87285588